You want them close enough so that the jumper cables will reach, but not so close that they touch. Turn off the ignition of both cars, make sure both cars are in park or in neutral if they have a manual transmission , put on the parking brakes and double check that all the car accessories are turned off. As you prepare to connect the cables, you may want to consider wearing protective eye equipment as well as safety gloves. If the battery in the dead car is cracked or leaking, do not try to jump the vehicle as doing so could cause an explosion. If the terminals on either battery are corroded, wipe them clean while wearing gloves to protect your hands to ensure that the clamps can make a solid connection. Connect the other end of the negative cable to an unpainted metal surface on the engine of the dead car.
The Official Way to Jump-Start a Battery
How to Charge a Car Battery - Easy Instructions | Meineke Blog
The wiring mess is an item which can be found inside the garage at home. It is used to wire up the Satsuma 's critical components as well as accessories. There are a total of 26 wires that can be attached. They do not need to be attached in any particular order, and some wires are not required for the car to start. After all the wires have been attached, bolt in the 8mm positive bolt on the battery red , then the negative bolt black. Tightening the negative bolt first causes sparking, and not disconnecting the negative bolt will cause the car to catch fire. Sign In Don't have an account?
ASK A BRAND
This brief guide will explain the best way of going about this. Rubber gloves may be handy to prevent and grease, oil or electrical sparks during this exercise. You should find the battery is a rectangular box under the bonnet of your car. However, many newer cars now have a cover for the battery with a battery symbol on top of it which you will have to slide off or lift up to locate the terminals.